Nilfisk-Advance MC 6P - Storing the Cleaner (below 0°C)

19
1)
Options / model variants
Original instructions
MC 5M - MC 6P - MC 7P
,
6.5 Storing the cleaner
(below 0°C)
Store the cleaner in a dry room without danger of frost or protect as
below:
CAUTION!
If the high-pressure cleaner is stored in a room with temperatures
around or below 0°C, anti-freeze should be drawn into the pump
beforehand:
1. Remove the water inlet hose from the cleaner.
2. Remove the spray lance.
3. Switch on the cleaner with the main switch in position
" I " and activate trigger on the spray gun.
Switch off the cleaner after max. 3 minutes.
4. Connect the suction hose to the water inlet of the cleaner and
place it in a tank containing anti-freeze.
5. Switch on the cleaner with the main switch in position " I ".
6. Hold the spray gun over the tank containing anti-freeze and oper-
ate it to start suction.
7. During suction operate the spray gun two or three times.
8. Lift the suction hose from the tank containing anti-freeze and op-
erate the spray gun to pump off the remaining antifreeze.
9. Switching off the cleaner
10. To avoid any risks, store the cleaner temporarily in a heated room
before using it again.
2. At last turn, lock the cable
end in the cable lock (C).
C