Nilfisk-Advance MC 6P - Connecting the High-Pressure Hose; Connecting the Water Supply Hose

8
1)
Options / model variants
Original instructions
MC 5M - MC 6P - MC 7P
3.5 Connecting the water
supply
1. Rinse the water supply hose
briefly in order to prevent
sand and other dirt particles
entering into the machine.
2. Connect water supply hose
to the machine.
3. Open water tap.
3.4.2 Machines with high
pressure hose reel
1. Put the quick connector of
the high pressure hose (A)
onto the nipple on the axle.
2. Put the high pressure hose
into the hose guide (B) and
fix it with the clip
1)
.
3. Release the brake (C) on the
hose reel guide
1)
and wind up
the high pressure hose.
A
B
C
3.3 Fill up detergent tank
1)
1. Fill up detergent tank with
prediluted Nilfisk detergent.
2. Pull detergent hose and filter
out of the storage and put it
through the opening of the
detergent tank filler cap.
3.4 Connecting the high
pressure hose
3.4.1 Machines without high
pressure hose reel
1. Put the quick connector of
the high pressure hose onto
the nipple on the cleaner.
NOTE!
The maximum length of
high pressure hose is 50 m.