Nilfisk-Advance MC 6P - Pressure Regulation with Tornado Plus Lance; Pressure Regulation with FlexoPowerPlus Nozzle; Using Cleaning Agents

13
1)
Options / model variants
Original instructions
MC 5M - MC 6P - MC 7P
MAX
CHEM
MAX
CHEM
4.3 Pressure regulation
with Tornado Plus
lance and
PowerSpeedVario Plus
lance.
1. Turn the twist grip on the
lance:
– High pressure =
clockwise (+)
– Low pressure =
anticlockwise (–)
4.4 Pressure
regulation with the
FlexoPowerPlus
nozzle head and the
PowerSpeedVario Plus
lance.
1. Twist cap of the FlexoPower-
Plus nozzle head:
– High pressure = MAX.
– Low pressure = MIN.
(CHEM)
4.5 Using cleaning agents Cleaning agent can be drawn
in via the injector installed as
standard only in low-pressure
mode:
1. Dilute cleaning agent accord-
ing to the manufacturer‘s in-
structions.
2. Tornado Plus lance and Pow-
erSpeedVario Plus lance
1)
:
Set pressure regulation on
spray lance to low pressure
(–), or FlexoPowerPlus
nozzle head
1)
:
Turn cap of the FlexoPow-
erPlus nozzle head towards
„CHEM“ up to the stop.
3. The intaken volume of clean-
ing agent can be regulated by
turning the metering valve.
4. Select tank A by turning the
merering valve on "A-side".
Select tank B by turning the
metering valve on "B-side"
5. Main switch
Turn the switch to position
" I ".
6. Operate the spray gun.
NOTE!
Never allow cleaning agent
to dry on the surface to be
cleaned. The surface may be
damaged.