Nilfisk-Advance SC2000 - Scrubbing and Drying Operation; Adjusting Solution Flow Rate; Technique for Edge Cleaning; Stopping Scrubbing;Drying Cycle

INSTRUCTIONS FOR USE ENGLISH
9100000383 - SC2000 15
01/2015
5. Adjust the solution ow by pressing the push-button (47) as necessary, depending on the type of cleaning to be performed.
NOTE
For the rst 3 ow levels (Fig. 4), the amount of solution dispensed is automatically adjusted according to the machine
speed, in order to obtain a constant amount of solution per linear meter of cleaning.
Level 4 (when enabled) supplies the maximum possible quantity of detergent solution, regardless of the machine speed
(to enable or disable this, see the Super User key section in the Maintenance chapter).
The level 0 closes the solution ow completely.
0,75 cl/m OFF1,5 cl/m 3,0 cl/m 2,8 l/min
4
3
2
1 0
Lev.Lev.
Lev.
Lev.
Lev.
Figure 4
P100866
NOTE
For correct scrubbing/drying of oors at the sides of the walls, Nilsk suggests to go near the walls with the right side of
the machine as shown in gure 5.
B
A
Figure 5
P100867
6. To stop scrubbing/drying, press the push-button (43) and wait for the brush deck (7) to lift. After 10 seconds, the vacuum
system turns off too and the squeegee (13) lifts.