MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be dened by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualied personnel, or by an authorised Service
Center.
CAUTION!
When the Service icon appears on the display (51), contact an authorised Nilsk Service Centre for
scheduled maintenance.
This Manual describes only the simplest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after using
the machine
Weekly
Every six
months
Yearly
Battery Charging
Squeegee Cleaning
Brush/pad cleaning
Recovery tank and debris tray cleaning, and cover gasket check
EcoFlex™ system (optional) cleaning and draining
Squeegee blade check
Solution Filter Cleaning
Battery (WET) uid level check
Squeegee blade replacement
Electromagnetic brake efciency check (1)
Brush/pad-holder motor carbon brush check or replacement (1)
Drive system motor carbon brush check or replacement (1)
(1) This maintenance procedure must be performed by an authorised Nilsk Service Center.
To Next Page
Loading...
Need help?
General
