SCRAPPING
Have the machine scrapped by a qualied scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Batteries
– Brushes
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Nilsk Center especially when scrapping electrical and electronic components.
Machine material composition and recyclability
Type Recyclable
percentage
SC2000 weight percentage
Aluminium 100 % 3 %
Electric motors - various 29 % 32 %
Ferrous materials 100 % 23 %
Wiring harness 80 % 7 %
Liquids 100 % 0 %
Plastic - non-recyclable material 0 % 3 %
Plastic - recyclable material 100 % 3 %
Polyethylene 92 % 26 %
Rubber 20 % 2 %
To Next Page
Loading...
