Nilfisk-Advance SC2000 - Battery Type Configuration; Alarms Log Screen Access; Operating Time Counter Access

INSTRUCTIONS FOR USE ENGLISH
9100000383 - SC2000 21
01/2015
(**) As described in the Use chapter, set the machine and the on-board battery charger (where tted) on the basis of the type of
battery to be installed by modifying the BAT parameter from the table below:
Installed battery type Value
WET Wet cell batteries 0
GEL / AGM Generic GEL or AGM batteries 1
GEL DISCOVER GEL batteries or DISCOVER
®
brand 2
GEL OPTIMA GEL batteries or OPTIMA™ brand 3
GEL EXIDE GEL batteries or EXIDE
®
/SONNENSHINE brand 4
GEL FULLRIVER GEL batteries or FULLRIVER
®
brand 5
Alarms log screen (G, Fig. 8)
This function allows you to check for any stored alarms on the
machine.
Use this function only with support from a Nilsk Service Centre
to solve any operating problems.
To return to the main screen (E, Fig. 7), press push-button (A)
repeatedly.
G
A
Figure 8
P100870
Operating Time Counter Screen (H, Fig. 9)
This function allows you to check the total accumulated hours of
work for each machine subsystem:
– TOTAL counter (machine running time)
– DRIVE counter (drive system usage time)
– BRUSH counter (brush rotation system usage time)
– VACUUM counter (vacuum system usage time)
To return to the main screen (E, Fig. 7), press push-button (A).
H
A
Figure 9
P100871