(For machines with EcoFlex™ system)
4. Fill the tank (21) with clean water. Use the water removable ller hose (23).
Do not ll the tank completely, leave a few inches from the edge. Use the level hose (13) as reference.
The water temperature must not exceed 40 °C.
Detergent tank lling (For machines with EcoFlex™ system)
WARNING!
When using oor cleaning detergents, follow the instructions on the labels of the detergent bottles.
To handle oor cleaning detergents, wear suitable gloves and protections.
5. Lift the cover (34) and check that the recovery tank (33) is empty; if not, empty it using the drain hose (12).
6. Close the cover (19).
7. Grasp the handle (16) and carefully lift the tank (33).
8. Fill the tank (25) with a detergent suitable for the work to be performed (highly concentrated detergent).
Do not ll the detergent tank completely, leave a few inches from the edge.
CAUTION!
Use only low-foam and non-ammable detergents, intended for automatic scrubber applications.
NOTE
To accelerate lling of the hoses and system operation (with a new system, if the system has been emptied for cleaning,
etc.), it is a good idea to drain the EcoFlex™ system once or several times (see the procedure in the Maintenance
chapter).
MACHINE START AND STOP
Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. To turn on the machine, insert the operator key (41) in its slot on the control panel (3); if the key is already inserted, press the
push-button (42).
3. In the rst 2 seconds after machine start-up, the multifunction display (51) indicates the machine working hours (51-A) and the
type of batteries installed (51-B).
NOTE
Check the battery charge level.
When the multifunction display shows at least one segment of the battery symbol (51-C) which is on but not ashing, the
machine is ready for use.
When the battery symbol (51-C) shows just one segment ashing, the batteries have to be charged (see the procedure in
Maintenance chapter).
4. Drive the machine to the area it is required by starting it with your hands on the handlebar (1) and pushing the paddle (2)
forward to move forward, and backwards to move in reverse. The speed can be adjusted by pressing the paddle (2) more or
less. The maximum speed can be set with the push-buttons (46).
Stopping the machine
5. Stop the machine by releasing the paddle (2).
6. Turn off the machine by pressing push-button (42), or by removing the operator key (41) from the control panel (3).
NOTE
If the machine is on but not working, it automatically turns off after 2 minutes.
7. Make sure that the machine cannot move independently.
CAUTION!
In the event of an emergency when you must stop all machine functions immediately, disconnect the battery
connector (9).
Reset the machine functions by connecting again the connector.
MACHINE OPERATION (SCRUBBING/DRYING)
1. Start the machine as shown in the previous paragraph.
2. Lower the squeegee (29) with the pedal (8).
3. Press the One-Touch™ push-button (43) to lower the brush deck and start scrubbing and drying.
4. Start cleaning by manoeuvring the machine and pressing the paddle (2).
If necessary, adjust the maximum speed with the push-buttons (46).
5. Adjust the solution ow by pressing the push-button (49) as necessary, depending on the type of cleaning to be performed.
9099980000(2)11-2015.indb 14 05/11/2015 15:58:46
To Next Page
Loading...
Need help?
General
