WASHING WATER FILTER CLEANING
1. Drive the machine on a level oor.
2. Ensure that the machine is off and the operator key (41) has been removed.
3. Close the washing water valve (A, Fig. 13). The valve is closed when it is in position (B) and it is open when it is in position (C).
4. Remove the transparent cover (D) and the gasket (E), then remove the lter strainer (F). Wash and rinse them, then ret them
carefully onto the lter support (G).
5. Open the valve (A).
D
F
E
G
AC
B
Figure 13
P100852
MACHINE TRACKING ADJUSTMENT
The machine tracking (straight movement) may vary according to the type of oor to be cleaned and depending on whether the
brush or the pad is used.
If it is difcult to keep the machine moving straight as it tends to pull to the left or to the right with the brush deck lowered and during
cleaning, adjust the handwheel (35) by turning it clockwise or counter-clockwise to correct this pull and obtain a generally neutral
straight-ahead movement.
9099980000(2)11-2015.indb 24 05/11/2015 15:58:49
To Next Page
Loading...
Need help?
General
