Nilfisk-Advance SC6000 910C Service Manual

21Service Manual – SC6000 04 - Control System
– Vac motors M4 and M5 – Wand mode (seat switch open upon entry) or Squeegee Actuator M6
◦ No recovery system fault (vac motors and squeegee)
◦ No Estop inhibit
◦ No impact lockout inhibit
◦ No low voltage cut out inhibit (second stage)
◦ No RTF inhibit
◦ Note M5 also requires Vacuum option set to dual in the conguration menu
• Solution System Outputs
– Solution Solenoid L1 –
◦ Scrub system active
◦ No solution solenoid fault
◦ No recovery system fault (vac motors and squeegee)
◦ Throttle command not equal to zero
◦ No Estop inhibit
◦ No impact lockout inhibit
◦ No low voltage cut out inhibit (rst or second stage)
◦ No RTF inhibit
◦ Not turned off with the membrane switch
◦ Not momentarily turned off by the solution timed off paddle switch input
– Spray wash pump M10
◦ No spray wash pump M10 fault
◦ Solution tank is not empty
◦ Option (Opt) pump in conguration menu set to “Spray Wash”
• Detergent System outputs
– Detergent Pumps M8 and M9
◦ Solution system is active
◦ EcoFlex is enabled in the conguration menu
◦ Not turned off with the control panel detergent switch
• Side Sweep System Outputs
– Side Sweep Motor M3
◦ No sweep motor M3 fault
◦ Scrub brushes active
◦ Side Sweep set to “yes” in the conguration menu
◦ Side Sweep switch open
– Dust Guard Pump M10
◦ No dust guard solenoid L2 fault
◦ No option pump M10 fault
◦ Side sweep motor active
◦ Solution tank is not empty
◦ Option (Opt) pump in conguration menu set to “Dust Guard”
◦ No Estop inhibit

Nilfisk-Advance SC6000 910C Specifications

General

Brand	Nilfisk-Advance
Model	SC6000 910C
Category	Scrubber
Language	English