EasyManuals Logo

Nilfisk-Advance SC800 User Manual

Nilfisk-Advance SC800
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
ENGLISH / A-19
FORM NO. - 56041820 - SC750, SC800, SC750 ST, SC800 ST - A-19
!
!
2
6
29
16
14
24
12
30
A
L
H
I
B
4
J
D
C
G
H1
F
F6
F5
F1
F7
F8
WET SCRUBBING
NOTE: Make sure the Recovery Tank Lid (6) and the Recovery Tank Drain Hose (24) cap are properly seated or the machine will not pick-up water correctly. When
the batteries require recharging the Battery LOW Indicator (F8) will come on (SC750, SC800 models) or the Battery Indicator (E) will ash red (Standard models)
and the vacuum motor will shut off after 30 seconds. Transport the machine to a service area and recharge the batteries according to the instructions in the Battery
section of this manual.
WET VACUUMING
Fit the machine with optional attachments for wet vacuuming.
1 Disconnect the Recovery Hose (16) from the Squeegee (12).
2 Attach suitable wet pick-up tools to the hose (Available from Advance).
3 Turn the Master Key Switch (A) ON.
4 Press the Vacuum/Wand Switch (L) (SC750, SC800 models)
or (C) (SC750 ST, SC800 ST models) once to turn ON the vacuum motor.
The vacuum motor will run continuously until the switch
is pressed again to turn it OFF.
NOTE: The “Recovery Tank FULL” indicator is disabled
when the wand mode is activated.
The oat will stop the ow into the recovery tank.
SERVICE NOTE: Refer to the service manual
for detailed functional descriptions of all
controls and optional programmability.

Other manuals for Nilfisk-Advance SC800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance SC800 and is the answer not in the manual?

Nilfisk-Advance SC800 Specifications

General IconGeneral
BrandNilfisk-Advance
ModelSC800
CategoryScrubber
LanguageEnglish

Related product manuals