Why is there poor water pickup from my Nobles SPEED EX Floor Machine?
If you're experiencing poor water pickup with your Nobles Floor Machine, start by checking the vacuum hose port cover for looseness. Also, inspect the shut-off float, vacuum intake screen, and vacuum shoe for any clogs and remove any debris. Lastly, check the tank cover gaskets and replace them if they are worn.
What to do if my Nobles Floor Machine does not operate?
If your Nobles Floor Machine does not operate, there might be a faulty power cord, which requires replacement. Alternatively, a tripped circuit breaker could be the cause. In this case, unplug the power cord, determine the cause, and reset the 15 amp circuit breaker button. If the circuit breaker continues to trip, further assistance is needed.
How to fix uneven spray or carpet streaking with Nobles SPEED EX?
If your Nobles Floor Machine has uneven or no spray, resulting in carpet streaking, ensure the cleaning mode switch is properly set. Next, inspect the spray tips for clogs and clean or replace them. Also, verify that the spray tip angle is correct. Check if the solution tank is empty and refill if necessary. Lastly, clean any debris from the solution hose screen.
What to do if the brush does not spin on my Nobles SPEED EX?
If the brush on your Nobles Floor Machine isn't spinning, it could be due to a tripped circuit breaker. Unplug the power cord, inspect the brush for any obstructions, and then reset the 5 amp circuit breaker button. For other potential causes, further assistance is needed.
General| Power Source | Electric |
|---|---|
| Motor Power | 1.5 HP |
| Cleaning Path | 20 inches |
| Cord Length | 50 ft |
| Voltage | 120V |
To Next Page