Nokia 7210 SAS-M - Page 112

File System Management
112
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
scp
Syntax scp local-file-url destination-file-url [router router-instance] [force]
Context file
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command copies a local file to a remote host file system. It uses ssh for data transfer,
and uses the same authentication and provides the same security as ssh. The following
prompt appears:
“Are you sure (y/n)?” The destination must specify a user and a host.
Parameters local-file-url — Specifies the local source file or directory.
Values
destination-file-url — Specifies the destination file.
user — Specifies the SSH user.
host — Specifies the remote host IP address of DNS name.
file-path — Specifies the destination path.
router-instance — Specifies the router name or service ID.
Values router-instance — user@hostname:file-path] | router-name
user — up to 32 characters
hostname — [dns-name | ipv4-address | ipv6-address]
ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x — 0 to FFFF (hexadecimal)
d — 0 to 255 (decimal)
interface — up to 32 characters max,
for link local addresses
dns-name — up to 128 characters
local-file-url — [cflash-id/] [file-path]
cflash-id or usb-flash-id — uf1: (7210 SAS-M)
cf1:, cf2:, uf1: (7210 SAS-T, 7210 SAS-Sx/S 1/
10GE: standalone and standalone-VC,
7210 SAS-Sx 10/100GE, and 7210 SAS-Mxp)
cf2:, cf2-A:, cf2-B:, uf1:, uf1-A:, uf1-B:
(7210 SAS-R6 and 7210 SAS-R12)
cf1:, cf2: (7210 SAS-Sx/S 1/10GE: standalone
and standalone-VC)