Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
Edition: 01 3HE 16132 AAAB TQZZA 125
• cf1:\ (internal flash)
• uf1:\ (external USB)
If the boot.tim is not found in any of these locations, the boot procedure fails. If the
boot.tim image is found, the system searches for bof.cfg (the boot options file) on the
same storage device in the root directory. For example, if boot.tim is found on cf2:\,
the system also looks for bof.cfg in cf2:\bof.cfg.
If bof.cfg is found, the system uses the BOF to locate the TiMOS software (both.tim
file), configuration file, and other boot parameters, and processes them to boot the
system. If the BOF is not found, the system attempts to retrieve the BOF from the
network using the auto-init mode and create a new BOF as part of the auto-init
process.
Refer to the appropriate 7210 SAS chassis installation guide for more information
about booting the system using these options.
4.1.4.2 System Boot Options on 7210 SAS-T, 7210 SAS-R6, and
7210 SAS-R12
These 7210 SAS platforms support the following options to retrieve the boot.tim and
TiMOS/SROS images (both.tim) required to boot the system:
• internal flash (cf1:\)
• external flash (cf2:\)
• external USB flash (uf1:\)
• network (with auto-init)
This option is supported only on the 7210 SAS-T.
• network (without auto-init)
Because multiple storage locations are available for the bootstrap image boot.tim file
on the 7210 SAS-T, 7210 SAS-R6, and 7210 SAS-R12, these platforms do not
support the golden bootstrap image.
During bootup, the bootrom searches for the boot.tim in the following locations in the
specified order and uses the image obtained from the first location where boot.tim is
found to load the bootstrap image:
• cf1:\ (internal USB)
• cf2:\ (external flash)
• uf1:\ (external USB)

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English