Nokia 7210 SAS-M User Manual

System Management
306
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
• The 7210 SAS host tracks the following events related to the modules in Slot 3
and Slot 4:
- line card/module removal and insertion
- provisioning mismatch, if the provisioned line card does not match the
equipped line card
- LoS alarm reported by the card/module for remote filter. The LoS alarm is
cleared by the ec-dw/ec-dwa based on the threshold configured VOA.
- monitoring power levels for remote filter is not supported and configuration
of power thresholds for automatic power monitoring feature supported by
the remote filter units is not allowed
- 1830 DWDM fan module insertion and removal
• Slot 5 hosts the fans or the Inventory Extension Module (IN/MOD). If the
7210 SAS is managing the 1830 device, provisioning Slot 5 is not supported. As
a result, only the fan module can be equipped in the slot; IN/MOD is not
supported.
6.6.3 1830 VWM Configuration Guidelines and
Restrictions
The 7210 SAS manages the 1830 VWM CWDM/DWDM clip-on device, and
inventory, and displays information about the clip-on device including part numbers,
clip-on type, manufacturing dates, firmware revision, and status of alarms. The
7210 SAS also supports provisioning of modules that can be inserted into the
available slots on the 1830 device. The following are the configuration guidelines and
restrictions that apply to the 1830 VWM.
• The shelf-ID on the rotary dial must be set to a numeric value between 1 to 7.
Digits higher than 7 are not supported by 7210 SAS devices.
• The 1830 VWM clip-on device is connected to a master-shelf (for example, a
7210 SAS device). Each clip-on device is identified using the shelf ID set on the
rotary dial provided on the device. To aid inventory management, the user must
configure the vwm-shelf-id of the clip-on device attached to the USB interface or
the OMC interface. The vwm-shelf-id must match the shelf ID that is set using
the rotary dial on the clip-on device. The 7210 SAS uses the configured vwm-
shelf-id to communicate with the clip-on device. If the two shelf IDs do not match,
the 7210 SAS cannot interact with other devices and is unable to provide
information about the device. The 7210 SAS cannot detect a mismatch between
the configured vwm-shelf-id and the shelf ID set on the rotary dial.
• The 7210 SAS provides a show command to display the alarm status
information communicated by the clip-on device.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English