EasyManuals Logo

Nokia 7210 SAS-M User Manual

Nokia 7210 SAS-M
748 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #121 background imageLoading...
Page #121 background image
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
Edition: 01 3HE 16132 AAAB TQZZA 121
4.1.2.1.1 Ping Check in Auto-init Mode
After successful bootup using the Auto-init Mode procedure, the software initiates a
ping check to ensure that the system has IP connectivity. The software loads the
configuration file and attempts to ping the destination node three times using the IP
address specified in the ping-address BOF parameter. If the ping check does not
succeed, the system is rebooted with the BOF reset after 1 minute and the boot
process is repeated. If the address in the BOF is zero or the ping address is not
specified, the ping check is not performed.
4.1.2.2 Manual Mode
Manual mode has two options.
• Either use the starter BOF or configure the BOF to point to a local image to use
the image files on the flash that are shipped with the node.
• Configure the BOF to retrieve the image files from the network.
If the user opts for the manual mode boot procedure using the network to retrieve the
images and configuration for the first-time boot, the required parameters must be
specified for a successful system boot. Manual mode configurations require
authentication. The default password is password. BOF parameters that should be
configured include the following:
• image path
• configuration file path
• uplinkA parameters (port number, VLAN ID, IP/mask, static route)
• uplinkB parameters (port number, VLAN ID, IP/mask, static route)
• eth-mgmt-disable
Note: The following caveats apply for manual mode on 7210 SAS platforms.
• UplinkA and uplinkB parameters are only supported on the 7210 SAS-M, 7210 SAS-T,
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE operating in standalone mode, and
7210 SAS-Sx 10/100GE.
• On 7210 SAS-R6 and 7210 SAS-R12, the out-of-band (OOB) Ethernet management
port can be used to retrieve the image and configuration file from the network.
• The auto-init mode is not supported on 7210 7210 SAS-Sx/S 1/10GE (standalone-VC),
7210 SAS-R6, and 7210 SAS-R12.

Table of Contents

Other manuals for Nokia 7210 SAS-M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nokia 7210 SAS-M and is the answer not in the manual?

Nokia 7210 SAS-M Specifications

General IconGeneral
BrandNokia
Model7210 SAS-M
CategoryCell Phone
LanguageEnglish

Related product manuals