To Next Page

To Previous Page

CLI Usage

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System

Configuration Guide

3HE 16132 AAAB TQZZA Edition: 01

2.7.4 Absolute Paths

CLI commands can be executed in any context by specifying the full path from the

CLI root. To execute an out-of-context command enter a forward slash “/” or

backward slash “\” at the beginning of the command line. The forward slash “/” or

backward slash “\” cannot be used with the environment alias command.The

commands are interpreted as absolute path. Spaces between the slash and the first

command will return an error. Commands that are already global (such as ping,

telnet, exit, back, etc.) cannot be executed with a forward slash “/” or backward slash

“\” at the beginning of the command line.

*A:ALA-12# configure router

*A:ALA-12>config>router# interface system address 1.2.3.4

*A:ALA-12>config>router# /admin save

*A:ALA-12>config>router# \clear router interface

*A:ALA-12>config>router#

The command may or may not change the current context depending on whether or

not it is a leaf command. This is the same behavior the CLI performs when CLI

commands are entered individually, for example:

*A:ALA-12# admin

*A:ALA-12>admin# save

*A:ALA-12# admin save

*A:ALA-12#

Note that an absolute path command behaves the same as manually entering a

series of command line instructions and parameters.

For example, beginning in an IES context service ID 4 (IES 4),

CLI Syntax: config>service>ies> /clear card 1

behaves the same as the following series of commands.

Example: Example:config>service>ies>exit all

clear card 1

configure service ies 4 (returns you to your starting

point)

config>service>ies

Nokia 7210 SAS-M User Manual

Other manuals for Nokia 7210 SAS-M