Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Virtual Chassis
Edition: 01 3HE 16132 AAAB TQZZA 229
The following output is an example of a CPM-IMM node configuration.
A:Dut-A# show bof
========================================================================
BOF (Memory)
========================================================================
primary-image ftp://*:*@135.250.127.36/./images/7xxx-hops/
primary-config cf1:\default.cfg
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address 10.135.17.166/24 active
eth-mgmt-address 10.135.17.167/24 standby
eth-mgmt-route 10.250.0.0/16 next-hop 10.135.17.1
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
vc-stack-name VC-3
vc-stack-node-type cpm-imm
vc-stack-node cpmA slot-num 1 mac-addr d0:99:d5:91:1c:41
vc-stack-node cpmB slot-num 2 mac-addr d0:99:d5:90:1e:41
=======================================================================
5.2.3 Manually Booting a VC IMM-Only Node
The IMM-only node can be booted independently of the CPM-IMM nodes. Perform
the following steps to manually configure IMM-only nodes in a VC.
Step 1. To boot the IMM-only node, use the SD card provided with the software
license that contains the appropriate boot.tim image.
Step 2. Upon power up, manually interrupt the boot process at the BOF prompt and
configure the following:
i. Specify standalone-vc for the boot loader parameter chassis-role.
ii. Specify imm-only for the boot loader parameter vc-stack-node-type.
iii. Note the MAC address of the IMM-only node. The MAC address used
for VC configuration is the chassis MAC address printed on the label of
the node.
You will need this information to configure the node in the TiMOS
context using the config>system>vc-stack-node slot-number mac-
address mac-address command on the active CPM, when the CPM is
up.
The slot number, image location, configuration location, IP addresses, and
route information do not need to be configured on the IMM-only node.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English