7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
Edition: 01 3HE 16132 AAAB TQZZA 157
persist off
console-speed 115200
no console-disabled
host-type satellites
===============================================================================
Result of 'satclicmd'=0=0x0
A:7210SAS-Sx#
The following output is an example of a basic BOF configuration for the
7210 SAS-R6.
*A:dut-b>show# bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@xx.xxx.x.xxx/./images/sasr/cpm.tim
primary-config cf2:\MasterScaling_18_Aug_B.cfg
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address xx.xxx.x.xxx/24 active
eth-mgmt-address xxxx::xxxx/64 active
eth-mgmt-address xx.xxx.x.xxx/24 standby
eth-mgmt-route xx.xxx.x.x/16 next-hop xx.xxx.x.x
eth-mgmt-route xxx.xxx.x.x/16 next-hop xx.xxx.x.x
eth-mgmt-route xxx.xxx.x.x/16 next-hop xx.xxx.x.x
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
===============================================================================
*A:dut-b>show#
4.10.3 Common Configuration Tasks
This section describes the following basic system configuration tasks that must be
performed:
• Searching for the BOF
• Accessing the CLI
• Procedure to Connect to a Console
• Configuring BOF Parameters
For details about hardware installation and initial router connections, refer to the
specific hardware installation guide.
To Next Page
Loading...
