Virtual Chassis
248
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
The slot number can be set to any number from 1 to 8 as long as it is not in use by another
VC member node. The slot number identifies a specific node or card in the VC similar to the
slot ID of a card in a chassis-based system, and is used in addressing service objects created
during provisioning.
An arbitration process in the boot phase ensures that one of the CPM-capable nodes is the
active CPM and the other is the standby CPM. Internally software will always assign CPM A
as the active CPM-IMM node and CPM B as the standby CPM-IMM node. Ports on the logical
IMM which is part of the CPM are referred to using the same format as IMM-only nodes (slot-
id/1/port-id).
The MAC address must match the chassis MAC address of the node.
The no form of the command removes the node from the VC.
Parameters cpmA — Specifies the active CPM-IMM.
cpmB — Specifies the standby CPM-IMM.
slot-num — Specifies the slot number of the node.
Values 1 to 8
mac-address — Specifies the chassis MAC address of the node.
Values xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx
To Next Page
Loading...
