Nokia 7210 SAS-M - Page 330

System Management
330
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
broadcastclient[router router-name] {interface ip-
int-name} [authenticate]
The following example shows the command usage to enable listening to NTP
broadcast messages.
Example: config>system>time>ntp#
config>system>time>ntp# broadcastclient interface int11
config>system>time>ntp# no shutdown
The following is a sample configuration of NTP enabled with the broadcastclient
parameter enabled.
A:ALA-12>config>system>time# info
----------------------------------------------
ntp
broadcastclient interface int11
no shutdown
exit
dst-zone PT
start second sunday april 02:00
end first sunday october 02:00
offset 0
exit
zone UTC
----------------------------------------------
A:ALA-12>config>system>time#
NTP-Server
This command configures the node to assume the role of an NTP server. Unless the
server command is used, this node will function as an NTP client only and will not
distribute the time to downstream network elements. If an authentication key-id is
specified in this command, the NTP server requires client packets to be
authenticated.
Use the following CLI syntax to configure the node to function as an NTP client only.
CLI Syntax: config>system>time>ntp
ntp-server [transmit key-id]
The following example shows the command usage to configure the node to function
as an NTP client only.
Example: config>system>time>ntp#
config>system>time>ntp# ntp-server transmit 1
config>system>time>ntp# no shutdown