Nokia 7210 SAS-M - Page 332

System Management
332
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Use the following CLI syntax to configure the node to operate in client mode.
CLI Syntax: config>system>time>ntp
server {ip-address |ptp}[key-id key-id] [version
version] [prefer]
The following example shows the command usage to configure the node to operate
in client mode.
Example: config>system>time>ntp#
config>system>time>ntp# server 192.168.1.1 key-id 1
config>system>time>ntp# no shutdown
The following is a sample configuration of NTP enabled with the server command
configured.
A:7210SAS>config>system>time>ntp# info
----------------------------------------------
ntp-server
server ptp prefer
broadcast interface "a1"
no shutdown
----------------------------------------------
A:7210SAS>config>system>time>ntp#
SNTP
SNTP is a compact, client-only version of the NTP. SNTP can only receive the time
from SNTP/NTP servers; it cannot be used to provide time services to other systems.
SNTP can be configured in either broadcast or unicast client mode.
SNTP time elements include:
• Broadcast-client
• Server-address
Use the following CLI syntax to configure the SNTP.
CLI Syntax: config>system
time
sntp
broadcast-client
server-address ip-address [version version-number]
[normal|preferred] [interval seconds]
no shutdown