Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 401
The user must create the VWM clip-on device and provision the shelf ID to allow the
7210 SAS software to communicate with the shelf and retrieve information. The value
specified in the vwm-shelf-id parameter must match the shelf ID set using the rotary dial on
the clip-on device. If these shelf IDs do not match, the 7210 SAS devices will not be able to
interact to the device and does not provide any information about the device. The software
cannot detect a mismatch between the value of the configured vwm-shelf-id and the shelf ID
set on the rotary dial.
In prior releases, the software allows user to configure only a single clip-on device for
management by specifying a single shelf ID. The software does not allow for configuration of
more than a single clip-on shelf.
A fixed number of 1830 VWM devices can be managed by the 7210 SAS devices. The limit
depends on the interface used to connect to the 1830 device. The user must provision all the
shelves that are connected to the 7210 SAS device.
The no form of this command removes the configured shelf ID and the software removes all
the information it has for the shelf.
Parameters vwm-shelf-id — Specifies the 1830 VWM clip-on device attached to a 7210 SAS device.
Values 1 to 7
create — Keyword to create the shelf ID.
vwm-shelf
Syntax [no] vwm-shelf vwm-shelf-id [vwm-type vwm-type] [create]
Context config>system
Supported
Platforms
7210 SAS-M (network and access-uplink), 7210 SAS-T (network and access-uplink), and
7210 SAS-Mxp
Description This command enables the context to configure the shelf information for 1830 VWM clip-on
device.
The user must create the VWM clip-on device and provision the shelf ID to allow the
7210 SAS software to communicate with the shelf and retrieve information. The value
specified in the vwm-shelf-id parameter must match the shelf ID set using the rotary dial on
the clip-on device. If these shelf IDs do not match, the 7210 SAS devices will not be able to
interact to the device and does not provide any information about the device. 7210 SAS
software cannot detect a mismatch between the value of the configured vwm-shelf-id and the
shelf ID set on the rotary dial.
Note: The vwm-shelf-id can take values in the range 1 to 7. This implies that the rotary
switch on the connected optical clip-on device must be set to a value in this range.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English