Nokia 7210 SAS-M - Page 410

System Management
410
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Description This command configures a MAC address for a VC. This command provides an option to
assign a MAC address other than the chassis MAC belonging to the CPM-A node. By
assigning the MAC address instead of using the chassis MAC address belonging to the CPM-
A node, operators do not need to change the MAC address when the CPM-A card is
physically replaced with another card.
The no form of this command reverts the value to the default MAC address specified in the
BOF.
Parameters mac-address — Specifies the MAC address of the VC.
6.12.2.1.4 System Alarm Commands
thresholds
Syntax thresholds
Context config>system
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables the context to configure monitoring thresholds.
kb-memory-use-alarm
Syntax kb-memory-use-alarm rising-threshold threshold [falling-threshold threshold] interval
seconds [rmon-event-type] [startup-alarm alarm-type]
no kb-memory-use-warn
Context config>system>thresholds
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures memory use, in kilobytes, alarm thresholds.
The no form of this command removes the parameters from the configuration.