System Management
442
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Parameters ip-address — Specifies the IP address of the SNTP server.
version version-number — Specifies the SNTP version supported by this server.
Values 1 to 3
Default 3
normal | preferred — Specifies the preference value for this SNTP server. When more
than one time-server is configured, one server can have preference over others. The
value for that server should be set to preferred. Only one server in the table can be
a preferred server.
Default normal
interval seconds — Specifies the frequency at which this server is queried.
Values 64 to 1024
Default 64
CRON Commands
cron
Syntax cron
Context config>system
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables the context to create scripts, script parameters and schedules that
support the Service Assurance Agent (SAA) functions.
CRON features are saved to the configuration file on both primary and backup control
modules. If a control module switchover occurs, CRON events are restored when the new
configuration is loaded. If a control module switchover occurs during the execution of a CRON
script, the failover behavior will be determined by the contents of the script.
schedule
Syntax schedule schedule-name [owner schedule-owner]
[no] schedule
Context config>system>cron
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
To Next Page
Loading...
Need help?
General
