7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 471
The no form of this command reverts the reference order to the default values.
Default bits1 bits2 ref1 ref2 (7210 SAS-Mxp)
ref1 ref2 ptp bits1 bits2 (7210 SAS-T)
ref1 ref2 (7210 SAS-M, 7210 SAS-Sx/S 1/10GE: standalone and standalone-VC,
7210 SAS-Sx/S 1/10GE and 7210 SAS-Sx 10/100GE)
bits1 ref1 ref2 ptp (7210 SAS-R6 and 7210 SAS-R12)
Parameters first — Specifies the first timing reference to use in the reference order sequence.
second — Specifies the second timing reference to use in the reference order sequence.
third — Specifies the third timing reference to use in the reference order sequence. This
parameter is supported only on 7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-R6, and
7210 SAS-R12 devices.
fourth — Specifies the fourth timing reference to use in the reference order sequence.
This parameter is supported only on 7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-R6,
and 7210 SAS-R12 devices.
fifth — Specifies the fifth timing reference to use in the reference order sequence. This
parameter is supported only on 7210 SAS-T and 7210 SAS-Mxp devices.
ptp — Specifies that PTP must be used as a timing reference.
ref1
Syntax ref1
Context config>system>sync-if-timing
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode; not supported on 7210 SAS platforms
configured in the standalone-VC operating mode
Description This command enables the context to configure parameters for the first timing reference.
ref2
Syntax ref2
Context config>system>sync-if-timing
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode; not supported on 7210 SAS platforms
configured in the standalone-VC operating mode
Description This command enables the context to configure parameters for the second timing reference.
To Next Page
Loading...
