7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 487
force-switchover
Syntax force-switchover [now]
Context admin>redundancy
Supported
Platforms
7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC
Description This command forces a switchover to the standby CPM/CFM card. The primary CPM/CFM
reloads its software image and becomes the secondary CPM/CFM.
Parameters now — Keyword to force the switchover to the redundant CPM/CFM card immediately.
switchover-exec
Syntax switchover-exec file-url
no switchover-exec
Context config>system
Supported
Platforms
7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC
Description This command specifies the location and name of the CLI script file executed following a
redundancy switchover from the previously active CPM/CFM card. A switchover can happen
because of a fatal failure or by manual action.
The CLI script file can contain commands for environment settings, debug (excluding
mirroring settings), and other commands not maintained by the configuration redundancy.
The following commands are not supported in the switchover-exec file: clear, configure,
candidate, oam, tools, oam, ping, traceroute, mstat, mtrace and mrinfo.
If the file-url parameter is not specified, no CLI script file is executed.
Parameters file-url — Specifies the location and name of the CLI script file.
Values file url — local-url | remote-url
255 chars max
local-url — [cflash-id/] [file-path]
remote-url — [{ftp:// | tftp://} login:pswd@remote-locn/] [file-path]
cflash-id — cf1:, cf1-A:, cf1-B:, cf2:, cf2-A:, cf2-B:, cf3:, cf3-A:, cf3-B:
rollback-sync
Syntax [no] rollback-sync
To Next Page
Loading...
Need help?
General
