7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 493
The no form of this command reverts to the default MAC address assignment scheme for
ports and LAGs. The use of the default configuration is not recommended; it is available only
to maintain the current mode of operation, if absolutely necessary.
Parameters v1-enable — Mandatory keyword that forces the system to use the new scheme of MAC
address assignment.
6.12.2.1.13 Rollback Commands
compare
Syntax compare [to checkpoint2]
compare checkpoint1 to checkpoint2
Context admin>rollback
Supported
Platforms
7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Mxp
Description This command displays the differences between rollback checkpoints and the active
operational configuration, with checkpoint1 as the base/first file to which checkpoint2 is
compared.
When no parameters are defined, this command compares the active configuration to the
most recent rollback file. when the checkpoint2 parameter is defined, this command
compares the active configuration to the specified file. When both checkpoint parameters are
defined, this command compares one specified file to another specified file.
A compare operation does not check authorization of each line of output. Permission to
execute the compare command should only be given to users who are allowed to view the
entire system configuration.
The defaults for checkpoint1 and checkpoint2 are context-aware and differ based on the
branch in which the command is executed. In general, the default for checkpoint1 matches
the context from which the command is issued.
Parameters checkpoint1, checkpoint2 — Specifies the configuration files to use as comparison
sources.
Values active-cfg — The active operational system configuration.
rescue — The rollback rescue file from the configured rescue
location.
latest-rb — The most recent rollback checkpoint file from the
configured rollback location, with the suffix *.rb.
To Next Page
Loading...
Need help?
General
