CLI Usage
62
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
The output of this command is similar to the output of a show config command. This
command, however, lists the configuration of the context where it is entered and all branches
below that context level.
By default, the command only enters the configuration parameters that vary from the default
values. The detail keyword causes all configuration parameters to be displayed.
Parameters detail — Displays all configuration parameters, including parameters at their default
values.
logout
Syntax logout
Context <GLOBAL>
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command logs out of the router session.
When the logout command is issued from the console, the login prompt is displayed, and any
log IDs directed to the console are discarded. When the console session resumes (regardless
of the user), the log output to the console resumes.
When a Telnet session is terminated from a logout command, all log IDs directed to the
session are removed. When a user logs back in, the log IDs must be recreated.
password
Syntax password
Context <ROOT>
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command changes a user CLI login password.
When a user logs in after the administrator forces a new-password-at-login, or the
password has expired (aging), then this command is automatically invoked.
When this command is invoked, the user is prompted to enter the old password, the new
password, and the new password again to verify the correct input.
If a user fails to create a new password after the administrator forces a new-password-at-
login or after the password has expired, the user is denied access to the CLI.
To Next Page
Loading...
Need help?
General
