7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 679
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables and configures debugging for NTP.
The no form of this command disables debugging for NTP.
Parameters router-name — Base, management
Default Base
ip-int-name — Specifies the name of the IP interface. The name can be up to 32
characters and must begin with a letter. If the string contains special characters (#,
$, spaces, and so on), the entire string must be enclosed within double quotes.
To Next Page
Loading...
