Appendix: 7210 SAS Boot Procedures
702
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Enter eth-mgmt IPv6 Address (Type 0 if none desired):
Step 12. At the prompt, enter 0. The following console output is displayed.
No eth-mgmt IPv6 Address configured
You specified network locations which might require
static routes to reach. You will be asked to
enter static routes until all the locations become
reachable.
Static routes should be entered in the following format:
prefix/mask next-hop ip-address
example: 192.168.0.0/16 next-hop 192.168.1.254
A static route to the Primary Image exists: 192.0.0.0/8 next-hop 10.135.25.1
Do you want to keep it? (yes/no)
Step 13. At the prompt, enter no. The following console output is displayed.
Enter route to Primary Image at 192.254.173.3:
Step 14. At the prompt, enter the static route for the specified primary image
location. The following console output is displayed.
A static route to the Primary Config exists: 192.0.0.0/8 next-hop 10.135.25.1
Do you want to keep it? (yes/no)
Step 15. At the prompt, enter yes. The following console output is displayed.
Enter route to Primary Config at 192.254.173.3 192.0.0.0/8 next-hop 10.135.25.1
Step 16. At the prompt, enter a static route for the specified primary configuration
location. The following console output is displayed.
Would you like to add a static route? (yes/no)
Step 17. At the prompt, enter yes. The following console output is displayed.
Enter ip route:
Step 18. At the prompt, enter a static route to the FTP server subnet (for example,
10.10.170.0/10 next-hop 10.135.4.1). The following console output is
displayed.
Would you like to add another static route? (yes/no)
Step 19. At the prompt, enter no. The following console output is displayed.
Would you like to add another static IPv6 route?
Step 20. At the prompt, enter no. The following console output is displayed.
Existing uplinkA port settings are:
uplinkA-port 1/1/65
To Next Page
Loading...
Need help?
General
