Nokia 7210 SAS-M User Manual

Appendix: 7210 SAS Boot Procedures
706
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
main
TiMOS BOOT LOADER
Time from clock is WED MAR 04 11:18:16 2020 UTC
Switching serial output to sync mode... done
Chassis-role is set to : standalone
Looking for uf1:/bof.cfg ... OK, reading
Step 2. The system locates the BOF on a local drive. The system reads the
contents of the BOF and displays it on the console.
The following console output is displayed.
Contents of Boot Options File on uf1:
primary-image uf1:\both.tim
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/67
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 100000
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/68
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 100000
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
Hit a key within 1 second to change boot parameters...
Step 3. At the prompt, wait until the specified wait time has elapsed. The boot
process can be interrupted at the prompt if necessary to change the boot
parameters (for example, the image location). In this example, it is
assumed that changes to the BOF are not required.
The following console output is displayed.
Configuring Network with uplinkA Port Setting.....
No existing config file URL
Primary image location: uf1:\both.tim
Loading image uf1:\both.tim
Version B-20.3.B1-1, Wed Feb 12 15:33:08 IST 2020 by sasbuild in /home/sasbuild/
20.3B1/panos/main
text:(41664192-->183719312) + data:(7133216-->49945144)
Executing TiMOS image at 0x2800000

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English