Standards and Protocol Support
744
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
RFC 7023, MPLS and Ethernet Operations, Administration, and Maintenance (OAM)
Interworking is supported on K12, K30, M(N), T(N), Mxp, Sx/S-1/10GE, Sx-10/
100GE, Sx/S-1/10GE-VC, R6, and R12
RFC 7267, Dynamic Placement of Multi-Segment Pseudowires is supported on K12,
K30, M(N), T(N), Mxp, Sx/S-1/10GE, Sx-10/100GE, Sx/S-1/10GE-VC, R6,
and R12
Quality of Service
RFC 2430, A Provider Architecture for Differentiated Services and Traffic
Engineering (PASTE) is supported on D, Dxp, K5, K12, K30, M(A,N), T(A,N),
Mxp, Sx/S-1/10GE, Sx-10/100GE, Sx/S-1/10GE-VC, R6, and R12
RFC 2474, Definition of the Differentiated Services Field (DS Field) in the IPv4 and
IPv6 Headers is supported on D, Dxp, K5, K12, K30, M(A,N), T(A,N), Mxp, Sx/
S-1/10GE, Sx-10/100GE, Sx/S-1/10GE-VC, R6, and R12
RFC 2598, An Expedited Forwarding PHB is supported on D, Dxp, K5, K12, K30,
M(A,N), T(A,N), Mxp, Sx/S-1/10GE, Sx-10/100GE, Sx/S-1/10GE-VC, R6, and
R12
RFC 3140, Per Hop Behavior Identification Codes is supported on D, Dxp, K5, K12,
K30, M(A,N), T(A,N), Mxp, Sx/S-1/10GE, Sx-10/100GE, Sx/S-1/10GE-VC,
R6, and R12
RFC 3260, New Terminology and Clarifications for Diffserv is supported on D, Dxp,
K5, K12, K30, M(A,N), T(A,N), Mxp, Sx/S-1/10GE, Sx-10/100GE, Sx/S-1/
10GE-VC, R6, and R12
RIP
RFC 1058, Routing Information Protocol is supported on Mxp
RFC 2082, RIP-2 MD5 Authentication is supported on Mxp
RFC 2453, RIP Version 2 is supported on Mxp
Timing
GR-1244-CORE, Clocks for the Synchronized Network: Common Generic Criteria,
Issue 3, May 2005 is supported on D-ETR, Dxp-ETR, K5, K12, K30, M(A,N),
T(A,N), Mxp, Sx/S-1/10GE, Sx-10/100GE, R6, and R12
GR-253-CORE, SONET Transport Systems: Common Generic Criteria. Issue 3,
September 2000 is supported on D-ETR, Dxp-ETR, K5, K12, K30, M(A,N),
T(A,N), Mxp, Sx/S-1/10GE, Sx-10/100GE, R6, and R12
IEEE 1588-2008, IEEE Standard for a Precision Clock Synchronization Protocol for
Networked Measurement and Control Systems is supported on D-ETR, Dxp-
ETR, K5, K12, K30, M(A,N), T(A,N), Mxp, Sx-1/10GE, R6, and R12
To Next Page
Loading...
