Replace a A-020W-A
40
7368 ISAM CPE A-020W-A Product Guide
3FE-47511-AAAA-TCZZA Issue: 01
6 Connect the power cable to the power connector.
7 Power up the unit by using the On/Off power button.
8 Verify the LEDs and voltage status.
9 Activate and test the services.
10 If necessary, reset the A-020W-A CPE.
i Locate the Reset button on a A-020W-A CPE, as shown in Figure 9.
ii Insert the end of a straightened paper clip or other narrow object into the hole in the
Reset button to reset the device.
11 STOP. This procedure is complete.
Note — Observe the following:
• Units must be powered by a Listed or CE approved and marked
limited power source with a minimum output rate of 12 V dc, 1 A. The
polarity of the power adapter plug must match the A-020W-A CPE.
Note — Resetting the device will return all settings to factory default
values; any configuration customization will be lost.
Release 05.08.01 | June 2018 | Edition 01
To Next Page
Loading...
