Configure a A-020W-A
80
7368 ISAM CPE A-020W-A Product Guide
3FE-47511-AAAA-TCZZA Issue: 01
Procedure 28 DMZ and ALG configuration
1 Select Security > DMZ and ALG from the top-level menu in the Ethernet Gateway window,
as shown in Figure 33.
Figure 33 DMZ and ALG window
Table 31 describes the fields in the DMZ and ALG window.
Table 31 DMZ and ALG parameters
2 Configure ALG.
3 Click Save ALG.
4 Configure DMZ.
Field Description
ALG Config Select the check boxes to enable the protocols to be supported by the ALG: FTP,
TFTP, SIP, H323, RTSP, L2TP, IPSEC, PPTP
DMZ Config
WAN Connection List Choose a WAN connection from the drop-down menu
Enable DMZ Select this check box to enable DMZ on the chosen WAN connection
DMZ IP Address Choose Customer Setting and enter the DMZ IP address or choose the IP address
of a connected device from the drop-down menu
Release 05.08.01 | June 2018 | Edition 01
To Next Page
Loading...
