7750 SR ESA 100G Chassis Installation Guide
Release 20.5
Installation
Issue: 01 3HE 16094 AAAA TQZZA 27
4.1.2 Rack-mounting the Chassis with Slide Rails
All model variants can be rack-mounted using slide rails.
Before starting this procedure, ensure that you have the following:
• slide rail kit
• additional screws and washers (not provided) for mounting the chassis in a rack
• a screwdriver (Phillips or flathead, depending on the type of screws used)
• an available grounding point near the installation location
To rack-mount the 7750 SR ESA 100G chassis using slide rails:
Step 1. Remove the rail from the package and extend the rail fully.
Step 2. Pull the white tab forward and remove the inner rail as shown in Figure 3.
Figure 3 Slide Rail Assembly
To Next Page
Loading...
