21
G-TIDE E66 User Manual
Finally, align the battery housing with the slot and push it up
till it clicks.
3.3 Installing and Removing SIM
This mobile phone is a dual-card, dual-standby ultra long
standby time model. It can be inserted with two SIM cards. In
the case of two GSM SIM cards, they will be registered on
the GSM network at the same time. Each SIM will be
normally inserted into one card slot. The SIM card inserted in
slot A is SIM 1, whereas the SIM card inserted in slot B is SIM
2.
Note: 1. It is required that both SIM 1 and SIM 2 are inserted
with SIM cards before the dual-card switching of the
mobile phone can be performed. If there is only one
card, the interface with a card cannot be switched to
the standby interface without a SIM card.
2. Presently GPRS functions (including MMS and wap)
are only supported by SIM1. SIM2 is not in support of
GPRS functions.
22
G-TIDE E66 User Manual
Power off the mobile phone, remove the battery and other
external power supply.
Insert the SIM in a parallel way with the metallic end going
first and metallic side facing down.
To remove the SIM card, please first power off the mobile
phone, take out the battery, and remove the SIM card from
the card slot.
3.4 Installing and Removing Saving Card
This mobile phone supports the T-Flash card (to be
purchased) which is a multimedia saving card to increase the
memory of the mobile phone.The card is small. During
installing or removing it, take special care to avoid damage.
Installation method of the T-Flash card:
1. Remove the battery.
2. Align the T-Flash downward with the slot and insert by
pushing till the end.
Removing method of the T-Flash card:
1. Remove the battery.
2. Take the T-Flash out.