Programming is completed when
Flashing Completed
message is displayed.
The product type designator and MCU SW version are displayed in the status bar.
vi Close the
Firmware Update
window and then choose File→Close Product .
2. Create a
Request
file.
For this procedure, you must supply +12 V to CU-4 from an external power supply.
i To connect the phone with
Phoenix
, choose File→Scan Product .
ii Choose Tools→Certificate Restore .
RM-179; RM-223
Baseband Troubleshooting
Issue 1 COMPANY CONFIDENTIAL Page 3 –57
Copyright © 2007 Nokia. All rights reserved.
To Next Page
Loading...
