ST-37 BTHFM rework stencil
ST-37 stencil is used with the RJ-104 rework jig to service the BTHFM
(D6000) module.
ST-40 Rework stencil
ST-40 is a rework stencil that is used with the RJ-93 rework jig to
service the Front End Module (N7520).
ST-55 Rework stencil
ST-55 is a rework stencil used with rework jig RJ-157 and RJ-160.
ST-59 Rework stencil
ST-59 is a rework stencil used with rework jig RJ-169.
SX-4 Smart card
SX-4 is a BB5 security device used to protect critical features in tuning
and testing.
SX-4 is also needed together with FPS-10 when DCT-4 phones are
flashed.
Cables
The table below gives a short overview of service tools that can be used for testing, error analysis and repair
of product RM-179; RM-223, refer to various concepts.
RM-179; RM-223
Service Tools and Service Concepts
Page 2 –14 COMPANY CONFIDENTIAL Issue 1
Copyright © 2007 Nokia. All rights reserved.
To Next Page
Loading...
