norbar PNEUTORQUE PT 9 - Trouble Shooting Guide; Common Problems and Solutions; Glossary of Terms

TROUBLE SHOOTING
The following is only a guide, for more complex faults please contact your local Norbar distributor or Norbar
directly.
Problem
Likely Solutions
Tool output does not rotate when trigger pushed.
Check air supply is functioning & connected.
Check air pressure setting (at least 1 bar).
Check correct setting of direction knob.
Output drive square sheared, needs replacing.
Gear train or air motor is damaged.
Drive square sheared.
See maintenance section to replace.
Tool does not stall.
Tool has not achieved torque, increase air pressure.
Fastener sheared or thread stripped.
Gear train or air motor is damaged.
GLOSSARY OF TERMS
Word or Term
Meaning
Air pressure graph
Graph supplied with Stall only tool to show air pressure setting against required
torque.
AUT
Auto Two speed.
CFM
Cubic Feet per minute (ft³/m), a measure of air flow.
BSP
British Standard Pipe, this is a thread size.
Lubro Control Unit
Unit to provide filtering and lubrication along with pressure regulation.
Included with some tools.
MTS
Manual Two Speed.
PneuTorque
®
Product name.
Reaction Arm
Device to counteract applied torque.
21