INTRODUCTION
The PneuTorque
®
Standard Series tools are non-impacting, air driven power tools designed for applying
torque to threaded fasteners. There are models to cover torque capacities of 680 N·m to 300,000 N·m. The
tools use an external air pressure regulator (included in a Lubro Control Unit supplied as an accessory) to set
the air pressure that controls the stall torque. The PneuTorque
®
must always be operated with the following:-
• Filtered dry air supply. Minimum recommended compressor rating: 6.9 bar (100 psi), 19 l/s (40 CFM).
• Lubro Control Unit or similar Filter, Regulator and Lubricator Unit ½” Bore (12 mm).
• Impact or high quality sockets.
• Reaction bar.
Parts Included
All tools include Operators Manual (Part number 34317), Calibration Certificate & Air pressure graph (Part
number 34208)
NOTE A: The output drive and reaction components must be engineered specifically for each
customer application. Consult Norbar.
Accessories
6” Nose Extension (¾” drive)
9” Nose Extension (¾” drive)
12” Nose Extension (¾” drive)
6” Nose Extension (1” drive)
9” Nose Extension (1” drive)
12” Nose Extension (1” drive)
To Next Page
Loading...