To Next Page
T
Terri OrtegaJul 25, 2025
What to do if norbar PNEUTORQUE PT 9 output does not rotate when trigger pushed?
- AAllen SavageJul 25, 2025
If the Norbar Tools output doesn't rotate when the trigger is pushed, there are several potential causes. First, check that the air supply is functioning and properly connected, ensuring the air pressure setting is at least 1 bar. Also, verify the correct setting of the direction knob. If these steps don't resolve the issue, the output drive square may be sheared and require replacement, or the gear train or air motor might be damaged.
General
