Norcold N611v - Install Decorative Door Panels

Installation and Owner’s Manual 19
- Make sure that the top edge of the bafe is
between 1/4 inch and 1/2 inch [213] below
the condenser and that there is 1/4 inch or
less clearance [15] between the rear of the
condenser and the bafe.
- For the best cooling performance, the
bafe should be 1/4 inch below the bottom
of the condenser.
- If the depth of the enclosure is more than 26 inches
[27], install a wood or an aluminum or galvanized
steel sheet solid box bafe [21] between the lower
intake vent and the upper exhaust vent (See
Art02526).
- Make sure that the solid box bafe is the full
width of the inside of the enclosure.
- Make sure that the bottom of the solid box
bafe is 18 inches to 18 1/2 inches above the
bottom of the enclosure [17].
- Make sure that the back of the solid box bafe
is perpendicular to the bottom of the enclosure.
- Make sure that the horizontal top of the solid
box bafe is even with the bottom edge of the
condenser [11].
- Make sure that the vertical top edge of the
bafe is between 1/4 inch and 1/2 inch [213]
below the condenser.
- Make sure that there is 1/4 inch or less
clearance [15] between the rear of the
condenser and the bafe.
Art02426
27
17
10
9
25
21
24
1513
15
11
15
213
The doors are made to accept decorative panels. The decorative panels must be 3/16 inch or less in thickness. Install
the decorative door panels in the refrigerator doors before installing the refrigerator in the vehicle.
- Make an upper door panel that is 21 19/32 inches wide x 14 17/32 inches high.
- Make a lower door panel that is:
- 21 19/32 inches wide and
- 31 5/8 inches high (for N611v models) or
- 38 5/8 inches high (for N811v models).
- Pull the panel retainer [37] off each door (See Art00965).
- Push the decorative door panel [38] into the slots of the door [39].
- Push each panel retainer into the slot on the edge of the door.
Install Decorative Door Panels
Art00965
37
38
39
NOTICE