5
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver .
See the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if
it has been preassembled. To avoid damaging parts, do not use power tools for assembly.
M8 x 18mm
Patch Screw
(80)–4
M8 x 45mm Button
Bolt (76)–4
M10 x 20mm Patch
Screw (79)–5
M10 x 95mm Patch
Screw (82)–4
M4 x 19mm
Screw (25)–4
M4 x 16mm
Screw (92)–6
M8 Washer
(33)–4
M10 Split
Washer (109)–5
M8 Locknut
(77)–4
M6 Locknut
(74)–4
M6 x 12mm
Screw (84)–12
M6 x 38mm
Bolt (108)–4
To Next Page
Loading...
