Index
ii
Part 1105120-03
E 2015 Nordson Corporation
E
Electrical
connections, system controller, 3-3
requirements, 3-3
Exhaust, requirements, 3-16
External blower, description, 2-3
External blower lampheads, parts, 7-7
External blowers, installation, 3-16
F
Fault, messages, 4-4
Fault output, 3-8
FAULT CURRENT IMBALANCE, 5-2
FAULT DeviceNet ERROR, 5-3
FAULT DEVNET HARDWARE, 5-3
FAULT EXT INTERLOCK, 5-4
FAULT FILAMENT FUSE BLOWN, 5-2
FAULT HARDWARE FAILURE, 5-3
FAULT HIGH CURRENT ON MAG, 5-2
FAULT HV CABLE UNPLUGGED, 5-5
FAULT LAMPHEAD OVER TEMP, 5-5
FAULT LOW CURRENT ON MAGS, 5-5
FAULT LOW LAMPHEAD PRESSURE, 5-4
FAULT MAG FILAMENT IS OPEN, 5-6
FAULT MAG POWER WHEN OFF, 5-2
FAULT MAG VOLTAGE ERROR, 5-3
FAULT NETWORK COMM, 5-3
FAULT NETWORK CONFIGURATION, 5-2
FAULT NO LIGHT DETECTED, 5-3
FAULT ON NETWORK UNIT, 5-2
FAULT PHASE CONTROLLER ERROR, 5-6
FAULT PHASE CTRL AT LIMIT, 5-5
FAULT POWER CTRL AT LIMIT, 5-4
FAULT POWER UNIT OVER TEMP, 5-4
FAULT RF DETECTOR FAILED, 5-5
FAULT RF DETECTOR MISSING, 5-4
Faults, resetting, 4-5
Filament transformer, replacement, 6-15
Filters
maintenance, 6-4
replacement, internal blower, 6-5
Focal lengths, 2-5
Frequency, of operation, 1-5
Fuses, replacing, 6-2
G
Glossary, 9-1
H
High voltage, safety, 1-6
I
Idle
function, 4-2
message, 4-4
Idle mode
activation, 3-10
cycle timing, 3-10
Input
Lamp on, 3-8
Machine stop interlock, 3-8
Off/reset, 3-8
remote power control, 3-8
Standby, 3-8
Inspection, before installation, 3-1
Intended Use, Of equipment, 1-2
Internal blower, description, 2-3
To Next Page
Loading...