Nordson Coolwave 2610 - Page 141

Index
iii
Part 1105120-03
E 2015 Nordson Corporation
L
L COOL, message, 4-4
Lamp on input, 3-8
Lamphead
air pressure, 4-2
blowers, 3-15
cable connection, 3-21
description, 2-2
dimensions, external blower version, 3-13
dimensions, internal blower version, 3-14
installation, 3-12
mounting kit, optional, 3-15
light shielding, 3-15
magnetron, 4-2
mounting guidelines, 3-12
moving and storage, 1-8
pressure monitoring, port selection, 3-18
repair, 6-5
specifications, 8-4
troubleshooting, 5-7
Lamphead, internal blower, parts, 7-4
Lampheads, external blower, parts, 7-7
LAMPON, message, 4-4
Lamps
operating temperature, 1-7
disposal of, 1-7
Light detector, description, 2-2
Light detector board, replacement, 6-18
Light output
displaying, 4-3
specifications, 8-3
LMPDLY, message, 4-4
Load balancing, 3-4
Local unit, startup, 4-9
M
Machine stop interlock, 3-8
connection, 3-9
Magnetron
description, 2-1, 2-3
replacement, 6-14
Magnetrons, Description, 2-4
Maintenance
filters, 6-4
lamphead, 6-4
magnetrons, 6-4
reflectors, 6-4
screen, 6-4
system controller, 6-1
Malfunctions, action in case of, 1-8
Mercury bulbs
disposal of, 1-7
safety when handling, 1-7
Messages
cool delay, 4-4
fault, 4-4
idle, 4-4
lamp delay, 4-4
lamp on, 4-4
operating, 4-4
standby, 4-4
warm up, 4-4
Microwave Radiation
exposure to, 1-5
RF screen protection, 1-5
Moving and storage, safety, 1-8
N
Network
cable part number, 7-11
connections, 3-7
selections, 4-2
termination, 3-7
O
Off/reset input, 3-8
Optional Two Axis Bracket Kit, Lamphead
mounting, 3-15
Options
AirShield Ventilation System, 2-8
description, 2-8
LiteTite Shutter, 2-8
Output
fault, 3-8
Ready, 3-8
Ozone, definition, exposure, 1-5