Installation
3-17
Part 1073401_07
E 2021 Nordson Corporation
You can exit the setup mode at any time by
pressing the Setup key.
Parameter numbers that are not applicable are
skipped when you scroll through the operating
parameter list in the left display.
When the right display is flashing, you can quickly
set the value of the current parameter to it’s
lowest possible value by simultaneously pressing
both of the right-display scroll keys.
While in the setup mode, if no key is pressed for
two minutes, the melter will return to the automatic
scan mode.
You can also use the right-display scroll keys to
enter or change a parameter’s value or control
option. After entering the parameter’s number in
the left display, press either of the right-display
scroll keys to change the value or control option.
If password protection is enabled, the melter will
return to the password protected mode whenever
you exit the setup mode.
Appendix B, Parameter 10
To Next Page
Loading...
Need help?
General
