Table of Contents
ii
Part 1024496_06
2014 Nordson Corporation
Installation 3-1.................................................
Quick‐Start 3‐1.................................................
Installing 400/480 Volt Melters 3‐1................................
Overview 3‐2..................................................
Additional Information 3‐2......................................
Installation Tasks 3‐3.........................................
Experience of Installation Personnel 3‐3.........................
Installation Requirements 3‐4....................................
Clearances 3‐4..............................................
Ventilation 3‐5...............................................
Electrical Power 3‐5..........................................
Compressed Air 3‐6..........................................
Other Considerations 3‐6......................................
Unpacking the Melter 3‐8........................................
Contents of the Installation Kit 3‐8...............................
Customer‐Supplied Materials 3‐8...............................
Mounting the Melter 3‐10.........................................
Configuring the Electrical Service 3‐13..............................
Connecting a Compressed Air Supply 3‐18..........................
Connecting Hoses and Guns 3‐20.................................
Setting Up the Melter 3‐24........................................
Quick Setup 3‐24..............................................
Operating Parameters 3‐26.....................................
Selecting Operating Parameters 3‐26..........................
Reading or Editing Operating Parameters 3‐26..................
Set‐point Temperature of the Tank, Hoses, and Guns 3‐32..........
Save and Restore Melter Settings 3‐34...........................
Review Parameter and Set‐point Temperature Changes 3‐36.......
Installing Melter Inputs 3‐40.......................................
Installing Melter Outputs 3‐44.....................................
Installing Optional Equipment 3‐47.................................
Connecting a Gun Driver, Pattern Controller, or Timer 3‐47.............
Flushing the Melter 3‐47..........................................
Setting Up Melter Communications 3‐47............................
To Next Page
Loading...
