Operation
4-6
Part 1024496_06
2014 Nordson Corporation
Monitoring the Melter
The melter provides indicators that allow you to:
Quickly confirm that the melter is operating correctly
Monitor the actual temperature of the manifold and each hose
and gun
Identify melter faults
Identify when the level of hot melt in the tank is low
Check the operating air pressure
Determine when service is required
The melter automatically determines the number and location of all
hoses and guns that are connected to it. Refer to More About
Heated Components earlier in this section for information about hose/gun
capacity and the identification of heated components.
You can also use a personal computer to monitor the melter. Refer to
Appendix C, Melter Communications, for information about connecting a
personal computer to the melter and installing the required software.
To Next Page
Loading...
