Nordson ProBlue P4 - To Set up an Input

Installation
3-42
Part 1024496_06
 2014 Nordson Corporation
Installing Melter Inputs (contd)
To set up an input
Set up the parameter control option for each input that you connected to the
melter. Table 3‐8 list the available control options. Refer to Setting Up the
Melter earlier in this section for information about how to select operating
parameters and edit parameter control options.
With the exception of the pump
enable/disable control option
(Table3‐8), All inputs are
transition‐based.
Appendix B, Input Setup
The input capacity of the melter may be
increased from four inputs to a total of
ten inputs by adding an optional I/O
card that is available from Nordson
Corporation.
Section 7, Parts